arekkusu's forum posts
it does it when i restart as well, i turned off the updates setting so its not that... someties if i log out first and then use the shutdown command form that point it works about 80% of the time, ive only had this computer for as long as ive had vista so i doubt defragging it would help much, if i check the Event Viewer i can find stuff that says "This application caused a delay in the system shutdown process" but its all like... windows system fiels for the most part likr this one "mobsync.exe" i dont know if theres a diagnostic i can run or something
try this if you get the 3 red light... some insight, this is form www.llama.com
- Turn the xbox 360 on, and wait till the 3 red lights are flashing.
- Press and hold the sync up button (the small white one), while holding that button press the eject button.
- The LEDs will now blink the first number in the code (as described below).
- Release the eject button and press it again.
- The LEDs will now blink the second number of the code.
- Release the eject button and press it again.
- The LEDs will now blink the third number of the code.
- Release the eject button and press it again.
- The LEDs will now blink the forth number of the code.
- Release the eject button and press it again.
- The LEDs will go back to the 3 red flashing lights.
Here is how you interpret the LEDs to get the code number:
- All four lights flashing - 0
- One light flashing - 1
- Two Lights flashing - 2
- Three lights flashing - 3
0002 power supply problem
...
0010 over heating
0011 over heating
0012 over heating
0013 over heating
...
0020 (Not yet known, possibly overheating)
...
0022 GPU Error / GPU Overheating
...
0102 unknown error - littereally means the console does not know what is wrong. possibly a short or cold solder joint somewhere (2 reports of people repairing this, one was removing moisture build up inside the console, the other used a hot-air rework to reflow the BGA Ram chips)
...
0110 (Not yet known)
...
1022 (Not yet known)
Log in to comment